LulzBot TAZ Pro S 3D Printer - Manual (Page 30)

28 | LulzBot TAZ Pro S
After removing filament, a small residual amount remains in the hot end that needs to be cleared out through the
process of purging as detailed above. This purging process helps to remove any residual material left in the hot end.
i
5.12 Once filament is
extruding, insert the filament
guide tube into the quick
connect on the top of the
extruder.
5.11 Select Extruder 1 and press the Load/Extrude - Continuous button and let filament advance until it
extrudes smoothly and consistently as shown. Press the Load/Extrude - Continuous button again to stop
extruding.