Motorola DCT3412 - Manual (Page 20)

3-4 Installation
Installation Overview
1 Determine if you are connecting to a:
High-definition
TV or monitor Use the component video (Y Pb Pr), HDMI, or IEEE 1394 outputs. No
other video connection supports HDTV.
Standard
definition TV Connect the S - VIDEO connector using an S-video cable, or connect the
composite VIDEO connector using an RCA phono cable. If the TV only
has a coaxial RF input, connect it to the DCT3412 RF OUT connector.
2 Determine if you are connecting the audio to a home theater receiver or directly to the TV:
ƒ For an HDMI or IEEE 1394 video connection, no additional audio connections to the TV
are required.
ƒ If the receiver or TV has an SPDIF input, use the optical spdif or coaxial spdif outputs.
ƒ Otherwise, use the baseband left and right audio out outputs.
3 Locate the cabling diagram(s) that best match the subscriber configuration.
4 Connect the audio and video cables in a manner matching that diagram.
5 Determine if you are connecting to a data device (see “Data Device Connections” in this
section). For installation details, refer to instructions included with the data device.
6 Connect the cable terminal to the coaxial cable wall outlet.
7 Perform the boot cycle, including the download to the terminal, as described in “Boot Cycle”
in this section.
8 Perform the operational check for the remote control.
9 Optimize the high-definition settings. See “Optimizing the High-Definition Settings” in this
section.
10 Verify that the appropriate configuration information has been downloaded using the
addressable controller, such as the DAC 6000.
DCT3412 Installation Manual