Motorola DCT3412 - Manual (Page 42)

4-2 Diagnostics
Using the Diagnostics
To use the diagnostics:
1 Ensure that the DCT3412 is installed with the base platform or Thin Client software and
that it is connected to an AC outlet.
2 Press POWER and immediately press SELECT to enable diagnostic mode. The Diagnostics
main menu is displayed on the OSD and “d01” is displayed on the front-panel LED:
DIAGNOSTICS
> d01 GENERAL STATUS
d02 PURCHASE STATUS
d03 OOB STATUS
d04 INBAND STATUS
d05 UNIT ADDRESS
d06 CURRENT CHANNEL STATUS
d07 UPSTREAM MODEM
d08 CODE MODULES
d09 MEMORY CONFIG
d10 KEYPAD/LED
d11 INTERFACE STATUS
d12 USER SETTING STATUS
d13 PVR/HDD STATUS
d14 DOCSIS
d15 APPLICATION SPECIFIC INFORMATION
d16 INTERACTIVE STATUS (displayed only when Thin Client is running)
E EXIT
Figure 4-1
Example of the LED for the main menu
MUTE MUTE
P
You can use the following keys to navigate the diagnostics menus:
ƒ Press
CHANNEL ▲, CHANNEL ▼, CURSOR ▲, or CURSOR ▼ to select d01 through E.
ƒ Press
CURSOR ◄, CURSOR ►, SELECT , or ENTER to execute the selected diagnostic.
ƒ Select E from the main menu or press
POWER to exit.
DCT3412 Installation Manual