Add a static route – NETGEAR N750 Wireless Dual Band Gigabit Router WNDR4000 User Manual
Page 79
Chapter 7. Advanced Settings
|
79
N750 Wireless Dual Band Gigabit Router WNDR4000 User Manual
Add a Static Route
1.
Select Advanced > Static Routes to display the following screen:
2.
Click Add to open the following screen.
3.
Fill in the fields:
•
In the Route Name field, enter a route name for this static route. This name is for
identification purpose only.
•
Select Private if you want to limit access to the LAN only. The static route will not be
reported in RIP.
•
Select Active to make this route effective.
•
Enter the destination IP address of the final destination.
•
Enter the IP subnet mask for this destination. If the destination is a single host, type
255.255.255.255
.
•
Enter the gateway IP address, which has to be a router on the same LAN segment as
the wireless router.
•
In the Metric field, enter a number between 2 and 15 as the metric value. This
represents the number of routers between your network and the destination. Usually,
a setting of 2 or 3 works.
4.
Click Apply to save your changes. The Static Routes table is updated to show the new
entry.