Internet or ethernet port leds are off, Wireless led is off, Cannot log in to the wireless router – NETGEAR N750 Wireless Dual Band Gigabit Router WNDR4000 User Manual
Page 90
90
|
Chapter 8. Troubleshooting
N750 Wireless Dual Band Gigabit Router WNDR4000 User Manual
•
Clear the router’s configuration to factory defaults as explained in
If the error persists, you might have a hardware problem and should contact Technical
.
Internet or Ethernet Port LEDs Are Off
If either the Ethernet port LEDs or the Internet LED does not light when the Ethernet
connection is made, check the following:
•
Make sure that the Ethernet cable connections are secure at the router and at the modem
or computer.
•
Make sure that power is turned on to the connected modem or computer.
•
Be sure that you are using the correct cable:
When connecting the router’s Internet port to a cable or DSL modem, use the cable that
was supplied with the cable or DSL modem. This cable could be a standard
straight-through Ethernet cable or an Ethernet crossover cable.
Wireless LED Is Off
If the Wireless LED stays off, check to see if the Wireless On/Off button on the router has
been pressed. This button turns the wireless radios in the router on and off. The 2.4 GHz and
5 GHz LEDs are lit when the wireless radio is turned on.
Cannot Log In to the Wireless Router
If you are unable to log in to the wireless router from a computer on your local network, check
the following:
•
If you are using an Ethernet-connected computer, check the Ethernet connection
between the computer and the wireless router as described in the previous section.
•
Make sure that your computer’s IP address is on the same subnet as the wireless router.
If you are using the recommended addressing scheme, your computer’s address should
be in the range of 192.168.1.2 to 192.168.1.254.
•
If your computer’s IP address is shown as 169.254.x.x, recent versions of Windows and
MacOS will generate and assign an IP address if the computer cannot reach a DHCP
server. These auto-generated addresses are in the range of 169.254.x.x. If your IP
address is in this range, check the connection from the computer to the wireless router,
and reboot your computer.
•
If your wireless router’s IP address was changed and you do not know the current IP
address, clear the wireless router’s configuration to factory defaults. This sets the
wireless router’s IP address to 192.168.1.1. This procedure is explained in
94.