5 connect the mvp harness to the audio panel – Electronics International MVP-50T User Manual

Page 37

Advertising
background image

4.5 Connect the MVP Harness to the Audio Panel:

If the voice alarms provided by the MVP are to be used, route the two MVP Voice Warning Out wires to the
Audio Panel, cut the wires to length and connect to the Audio Panel Aux input and ground. If an audio input is
not available on the Audio Panel (or an Audio Panel is not installed) you can connect the MVP Voice Warning
Out wires to the pilot headset jack. With this installation a 49.9 ohm 1/4 watt resistor will need to be installed
in series with the MVP +Voice Warning Out wire and the feed wire to the jack.

34

+Voice

(Wht/Blue, Pin 23)

-Voice

(Wht/Gray, Pin 24)

Audio Feed (from Radios)

Pilot's Audio Jack

49.9 Ohms

MVP

Voice Output

Gnd

To Gnd (Blk)
To 12V (Wht)
or
To 24V (Wht)

MVP

Back Light Cntrl

Input

(Wht/Org, Pin 25)

Wht/Brn

Wht/Red

Blk

Wht/Org

Moving Map Data In (Grn, Pin 8)
Fuel Flow Data Out (Wht, Pin 7)

4-Wire Cable

GPS

MVP

GPS Input &

Output

4.6 Connect the MVP Harness to the External Intensity Control Pot (CP-1):

If the MVP display intensity is to be controlled externally, route the MVP Back
Light Control In wire (orange) to the CP-1, cut the wires to length, install the
appropriate connectors (see the “Working with Connectors” section of this manual
for more information) and connect to the CP-
1. Install the ground and power wires to the
CP-1 as shown in the paper work supplied
with the control pot.

4.7 Connect the MVP Harness to the Moving Map Data Out from the GPS:

Route the MVP "Moving Map Data In" wire (green wire in a 4 wire cable) to the Moving Map Data Output Port
on the GPS. Cut the wire to length, install the appropriate connector and connect to the GPS port.

4.8 Connect the MVP Harness to the Fuel Data Input on the GPS:

If fuel data is to be viewed on the GPS, route the MVP "Fuel Data Out" wire (white wire in a 4-wire cable) to
the Fuel Data Input Port on the GPS. Cut the wire to length, install the appropriate connector and connect to
the GPS port.

Advertising