Edc wiring work sheet, Top connector (back view, wire side) – Electronics International MVP-50T User Manual
Page 48
EDC Wiring Work Sheet
Top Connector (Back View, Wire Side)
EDC-33T
EDC-33T
EDC-33T
EDC-33T
EDC-33T
EDC Input
EDC Pin #'s
(Wire Colors for Pressure Probes)
Function
Probe, Module or
Direct Connection to the EDC
Power & Gnd
+V Pin 37 (Red)
Gnd Pin 19 (Blk)
N/A
N/A
RS422 Out
RS422 +A Pin 17 or 18 (Wht/Grn)
RS422 -B Pin 35 or 36 (Wht)
N/A
N/A
Volts
No connection required. Volts is measured on
the Power Input pin 37.
VOLTS
EDC V-Pkup
Amps
+Amp Pin 32 (Orange)
-Amp Pin 33 (Brn)
AMPS
S-50
Fuel Flow
Inut Pin 14 (Wht)
+10V Pin 15 (Red)
Gnd Pin 16 (Blk)
FUEL FLOW
FT-60
Press Ch1
+5 Pin 20 (Red)
Gnd Pin 21 (Blk)
+In Pin 3 (Grn)
-In Pin 2 (Wht)
M.P.
PT-30ABS-.1
Press Ch2
+5 Pin 22 (Red)
Gnd Pin 23 (Blk)
+In Pin 5 (Grn)
-In Pin 4 (Wht)
FUEL P
PT-30GA-.1
Press Ch3
+5 Pin 24 (Red)
Gnd Pin 25 (Blk)
+In Pin 7 (Grn)
-In Pin 6 (Wht)
OIL P
PT-100GA-1
Press Ch4
+5 Pin 26 (Red)
Gnd Pin 27 (Blk)
+In Pin 9 (Grn)
-In Pin 8 (Wht)
Press Ch5
+5 Pin 28 (Red)
Gnd Pin 29 (Blk)
+In Pin 11 (Grn)
-In Pin 10 (Wht)
Press Ch6
+5 Pin 30 (Red)
Gnd Pin 31 (Blk)
+In Pin 13 (Grn)
-In Pin 12 (Wht)
An EDC Pressure Channel may be configured to measure a pressure or other functions. See the "List of Allowable Functions and Probes
for the EDC Inputs" for more information.
Note: Any EDC Input not used should be marked "N/A" under Function.
0425051-3
FT-180
PR ALT
PT-30ALT
Low Torq
PT-30GA (1/8” NPT)
Pin 35 (Wht/Red)
Volts Measured on Pin 35
PT-300GA (1/8” NPT)
Oil P.
PT-30ABS
PT-100GA (1/8” NPT)
FT-180
S-300 Shunt
Power and Ground Inputs.
RS422 Output to MVP
MVP-50T-PT6
MVP-50T-PT6
MVP-50T-PT6
MVP-50T-PT6
MVP-50T-PT6
High Torq
PT-100GA (1/8” NPT)
Note: Unused Pressure Inputs must be grounded.
Vo
lt
s
Wht/Red