Electronics International MVP-50T - Manual (Page 50)

EDC Wiring Work Sheet
Bottom Connector (Back View, Wire Side)
(Wht/Org)
EDC Input
EDC Pin #'s
& Wire Colors Function Probe
FL Ch 1
(Resistive Input)
Rin Pin 23 (Brn)
(Requires a RFLM-4 Module)
FL Ch 1
(Capacitive Input)
Cin Pin 20 (Wht)
+5V Pin 21 (Red)
Gnd Pin 22 (Blk)
FL Ch 2
(Resistive Input)
Rin Pin 4 (Org)
(Requires a RFLM-4 Module)
FL Ch 2
(Capacitive Input)
Cin Pin 1 (Wht)
+5V Pin 2 (Red)
Gnd Pin 3 (Blk)
FL Ch 3
(Resistive Input)
Rin Pin 35 (Yel)
(Requires a RFLM-4 Module)
FL Ch 3
(Capacitive Input)
Cin Pin 32 (Wht)
+5V Pin 33 (Red)
Gnd Pin 34 (Blk)
FL Ch 4
(Resistive Input)
Rin Pin 17 (Grn)
(Requires a RFLM-4 Module)
FL Ch 4
(Capacitive Input)
Cin Pin 14 (Wht)
+5V Pin 15 (Red)
Gnd Pin 16 (Blk)
RPM Ch 1 In Pin 26 (Wht/Brn) LEFT (mag) Ring Terminal Isolator
RPM Ch 2 In Pin 25 (Wht/Orange) RIGHT (mag) Ring Terminal Isolator
RPM 6-Cyl Select Open for 4 Cyl Engines.
Short Pin 28 to 27 for 6 Cyl Engines.
Temp Ch 16 +In Pin 12 (Yel)
-In Pin 30 (Red)
Temp Ch 17 +In Pin 13 (Yel)
-In Pin 31 (Red)
0425051-4
N1 (or Ng or Nh) Engine Tach Gen.
N2 (or NP or N L ) Engine Tach Gen.
Press Ch8
+In Pin 12 (Grn)
-In Pin 30 (Wht) +5 (use pin 15)
Gnd (use pin 11)
Press Ch9
+In Pin 13 (Grn)
-In Pin 31 (Wht) +5 (use pin 33)
Gnd (use pin 9)
Press Ch8 -In (Wht) Press Ch9 -In (Wht)
Press Ch8 +In (Grn) Press Ch9 +In (Grn)
+5 V
olts
EDC-33T EDC-33T EDC-33T EDC-33T EDC-33T MVP-50T-PT6 MVP-50T-PT6 MVP-50T-PT6 MVP-50T-PT6 MVP-50T-PT6
Note: Unused Pressure Inputs must be grounded.
Note: Resistive Fuel Level Inputs may also be used to measure Digital signals.
+5 V
olts
+5 V
olts
Do Not Use Do Not Use