Figure 3-3, Figure 3-4, Rem network with repeater – Innotech Device Network Cabling User Manual

Page 31: Figure 3-3: figure 3-4

Advertising
background image

Innotech Device Network Cabling Installation Instructions

© Mass Electronics Pty Ltd 2007

Chapter 3 – Sub Network Devices

Page 31

EXAMPLE 2:

This example shows a GENIIELD controller with a network of REM’s and an IR11 repeater fitted.

As in section one, once a repeater is installed there are effectively two networks and each must have

the EOL jumpers fitted.

Both ends must have the EOL jumpers fitted.

NOTE

Figure 3-3:  REM Network with Repeater

EXAMPLE 3:

This example shows a GENIIELD controller with a network of REM’s where the controller is in the

middle of the run.

Figure 3-4:  REM Network with Controller in the Middle of the run

Both ends of a run muse have the EOL jumpers fitted. It does not need to be a primary device.

NOTE

Advertising