Figure 3-7, Figure 3-8, Simple sub system network – Innotech Device Network Cabling User Manual

Page 34: Sub system network with a repeater, 5 end of line termination (eol), Figure 3-7: figure 3-8

Advertising
background image

© Mass Electronics Pty Ltd 2007

Innotech Device Network Cabling Installation Instructions

Edition 3.0 dated 05.12.2013

Page 34

3-5 End of Line Termination (EOL)

All devices on the Sub System Network have EOL jumpers and these must be fitted correctly. This is

shown in the figure below. There are many variations to network layouts. The following 4 examples

provide a guide to correct jumper application. These are similar to the REM network.

EXAMPLE 1:

This example shows a Sub System Gateway with a network of VAVMax and MiniMAX Controllers.

EXAMPLE 2:

This example shows a Sub System Gateway with a network of VAVMax and MiniMAX Controllers with a

repeater in the middle.

Both ends must have the EOL jumpers fitted.

NOTE

Figure 3-7:  Simple Sub System Network

Figure 3-8:  Sub System Network with a Repeater

Both ends must have the EOL jumpers fitted.

NOTE

Advertising