Table 3-2, Sub system network controllers and devices, Figure 3-5 – Innotech Device Network Cabling User Manual

Page 32: Rem network with repeater in the middle of the run, 2 sub system network

Advertising
background image

© Mass Electronics Pty Ltd 2007

Innotech Device Network Cabling Installation Instructions

Edition 3.0 dated 05.12.2013

Page 32

EXAMPLE 4:

This example shows a GENIIELD controller with a network of REM’s where there is a repeater fitted

and it is located in the middle of a run.

3-2 Sub System Network

The Sub System Network is a sub network that connects to the Innotech primary network via a

gateway. The Sub System Gateway IG01 is a data concentrator for the Sub System Network.

The Sub System Network is a two wire network that communicates at 115K. It is a requirement that

the EOL jumpers are fitted correctly and that each device is earthed correctly.

No devices on the Sub System Network have an earth terminal. All devices must have the 0V earthed.

There are currently five devices that exist on the Sub System Network. See the table below:

Figure 3-5:  REM Network with Repeater in the Middle of the run

Part Number

Comms

Terminals

Screen Type

Description

VM01

P+

+ -

P-

S

Soft Earth

VAV Maxim

MM02

S1

- S2

+

Soft Earth

Mini Maxim

UM01

P+

+ -

P-

S

Soft Earth

Micro Maxim

IG01

P+

+ -

P-

S

Soft Earth

Sub System Gateway

IR11

S1

- S2

+

Soft Earth

Repeater Single Channel

Table 3-2: 

Sub System Network Controllers and Devices

Advertising