Konica Minolta bizhub 4050 User Manual

Page 50

Advertising
background image

[Description of Utility Keys]

5-21

5.8

[Fax Settings]

5

[RX Mode ]

Select a receive mode.

[Auto RX]: Automatically start receiving a fax if the call is a fax call.

[Manual RX]: Manually request the reception of a fax. Select this option
when this machine is used with a telephone connected to it, which is fre-
quently used, and if you always prefer to receive faxes manually.

[Auto RX] is specified by default.

[Ring Pattern]

Select a fax ring pattern when the DRPD (Distinctive Ring Pattern Detection)
service is used.
When this machine receives a call signal of the selected pattern, fax receiving
starts automatically.
[Normal Ring] is specified by default.

Note

In general use, set this to [Normal Ring]. If DRPD is set by mistake in a region
where DRPD cannot be used, it will result in a fax receiving failure.

[Number of RX Call
Rings]

If necessary, change the number of times the phone rings before automatically
receiving a fax.
The default value depends on the region the machine is used in.

[Number of Redials]

If the machine fails to send a fax successfully, it automatically redials the same
destination after a certain period of time has elapsed. If necessary, change the
number of redials.
The default value depends on the region the machine is used in.

[Redial Interval]

If necessary, change the redial intervals when you specified a value in [Number
of Redials].
[3 min.] is specified by default.

[Line Monitor]

Select whether or not to play sounds on the telephone line from speakers dur-
ing fax communication.
[OFF] is specified by default.

[Line Monitor Sound
Volume (Send)]

Monitors sounds output from the machine. Specify the monitor sound volume
between 0 and 8.
This function is available only when [Line Monitor Sound] is set to [Until Con-
nection Complete] or [Until Transmission Complete].
[3] is specified by default.

Note

When communicating with fax, monitoring sound is generated even if send or
receive monitoring sound of this machine is set to [0] since the sound is gen-
erated both on this machine and on the destination side. For setting to mute,
set both [Line Monitor Sound Volume (Send)] and [Line Monitor Sound Volume
(Receive)] to [0], or set [Line Monitor] to [OFF].

[Line Monitor Sound
Volume (Receive)]

Monitors sounds output from the recipient, including switching equipment or
TA. Specify the monitor sound volume between 0 and 8.
This function is available only when [Line Monitor Sound] is set to [Until Con-
nection Complete] or [Until Transmission Complete].
[4] is specified by default.

Note

When communicating with fax, monitoring sound is generated even if send or
receive monitoring sound of this machine is set to [0] since the sound is gen-
erated both on this machine and on the destination side. For setting to mute,
set both [Line Monitor Sound Volume (Send)] and [Line Monitor Sound Volume
(Receive)] to [0], or set [Line Monitor] to [OFF].

[Manual RX V.34 OFF]

Select whether or not to automatically release the V.34 mode when manually
receiving a fax (G3).
[Enable] is specified by default.

Settings

Description

Advertising
This manual is related to the following products: