Roll tarp remote control troubleshooting, Roll tarp remote control troubleshooting -13 – Kinze Grain Carts Rev. 7/14 User Manual
Page 27
TM
Grain Cart
M0238-01
5/12
2-13
Operation
ROLL TARP REMOTE CONTROL TROUBLESHOOTING
PROBLEM
SOLUTION
No lights on remote turn on when I open
the lid.
Close lid for three seconds, then reopen lid.
Make sure there are no magnets close to the transmitter.
Open transmitter case and make sure battery is placed correctly in the
remote.
Remove battery and bend contacts closer together. Put battery back in
and try again.
The battery may be dead and must be replaced. Replacement
high-capacity batteries may be purchased from Shur-Co
®
(part #1704597).
SMARTransmitter
®
is damaged and must be replaced.
I can operate the system with rocker
switch but not the remote. The
SMARTransmitter
®
channel light is
blinking, and when I press the Open/On
button, the light blinks faster.
Make sure remote is set to the right channel. If you cannot set
remote to the desired channel, it must be reprogrammed (see
transmitter programming instructions).
Make sure no other transmitters are being used near your system.
Determine if the transmitter is the problem by testing it with a
different receiver or by using a second remote. If receiver was
the problem, reprogram receiver (see the receiver programming
instructions). If this doesn’t work, receiver should be replaced.
Make sure you are within a couple feet of the receiver
and try again. If transmitter works at short range but not at greater
distances, you have a range problem, so a new battery may be needed.
If the remote battery is not the cause, call the Help Line.
The SMARTransmitter
®
channel light is
blinking, but when I press the Open/On or
Close/Off button, the light goes out or just
continues to blink at the same speed.
Remove battery and bend contacts closer together. Put battery back in
and try again.
Battery may be dead and must be replaced. Replacement
high-capacity batteries may be purchased from Shur-Co
®
(part #1704597).
SMARTransmitter
®
is damaged and must be replaced.