Drive belts and pulleys, Gearbox oil level, Pto shaft coupling – Kinze Grain Carts Rev. 7/14 User Manual
Page 38: Drive belts and pulleys -2, Gearbox oil level -2, Pto shaft coupling -2, Lubrication and maintenance, Notice, Fill/check plug drain plug
M0238-01
Grain Cart
3-2
5/12
TM
Lubrication and Maintenance
See “V-Belt Tension Adjustment And Alignment” in Maintenance section for additional information.
4-Band V-Belts (2) Shown
DRIVE BELTS AND PULLEYS
NOTICE
Keep all oil and grease off V-belts and belt pulleys. Do not use belt
dressing on V-belts.
GEARBOx OIL LEVEL
Gearbox Oil Capacity . . . . . . . . 12⁄3 Gallons . . . SAE 90 weight oil.
Remove plug from fill/check plug hole on the gearbox. Oil level should be even with fill/check plug hole. Inspect oil at
end of each annual season of use for moisture and contaminates, if found, change oil before storage.
PTO SHAFT COUPLING
Clean and grease PTO shaft coupling each time PTO
is installed.
Apply a coating of high-speed industrial coupling grease,
such as Chevron
®
Coupling Grease meeting AGMA CG-1
and CG-2 Standards to extend life of shaft splines.
Vent Plug
1
ASSY GEAR BOX 57 DEGREE
A16008
1
1
SEAL 1.75-2.437-.312 (V) TC
R2095
2
1
SEAL 2.5-3.251-.375 (V)
R2096
3
22
HHCS 7/16-14 X 2.5 GR8 CS PLT
R2101
4
10
SCREW WET 5/8-11 X 3.25
R2102
5
1
PLUG 1/8-27 NPT VENT 5PSI
R2097
6
2
PLUG 1/2-14 PNT SCHD W/3M
R2099
7
QTY
DESCRIPTION
PART NUMBER
ITEM
IP1350
JASON LUCAS
Fill/Check Plug
Drain Plug