Kinze Grain Carts Rev. 7/14 - Manual (Page 69)

TM
Grain Cart M0238-01
5/12 3-33
Lubrication and Maintenance
Additional auxiliary work lights are available from Kinze
Repair Parts which may be wired into existing auxiliary
light wires in the harness. The vertical auger work light
is wired into the black terminal connector.
Grain cart safety/warning lights are the LED type and
meet ASAE standards. Check with tractor manufacturer
for correct wiring harness to be wired into lights on your
tractor.
WIRING DIAGRAM
ELECTRONIC SCALE
The major elements of the electronic scale are the
indicator, two 50,000 lb. rated compression type load
cells at the rear of the axle assembly (applicable to track
and flotation type carts) and four spindle type weigh axles
(applicable to row crop carts), 3¾" hitch weigh beam, the
junction box (j-box) and the battery power cable.
For additional information see “Electronic Scale
Troubleshooting” for step-by-step procedures for
troubleshooting failures that may be encountered with the
electronic scale.
The only tools required are as follows:

Small Screwdriver (Straight Blade)
 No. 2 Phillips Screwdriver
R.H. Axle
Load Cell
L.H. Axle
Load Cell
Junction
Box
Hitch Weigh
Beam
Indicator
(On Tractor)
Battery Power Cable
Red (+)
Black (-)