Lenze E94AYAE SM301 - Manual (Page 124)

Safety engineering
Appendix
Module internal codes
1
l
124 EDS94AYAE EN 7.0
Index: Data type: Name: Parameter:
C15308 SS2 mode UNSIGNED_8 9267 d = 2433 h
Selection whether SS2 is to be executed already after reaching n=0 SOS or only after reaching the parameterised
stopping time.
Selection list (Lenze setting bold) Information
0 SOS after stopping time (As of SM301 V1.3)
1 SOS at n = 0
þ Read access } Write access o Controller inhibit o PLC-STOP o No transfer
C15310 Tolerance window (n=0) INTEGER_16 9265 d = 2431 h
Safely monitored tolerance window for zero speed
Setting range (min. value | unit | max. value) Information
0 rpm 16000 Lenze: 0
þ Read access } Write access o Controller inhibit o PLC-STOP o No transfer
C15311 SOS: Tolerance window (Delta p=0) UNSIGNED_32 9264
d
= 2430
h
Safely monitored tolerance window for zero position change
Display area (min. value | unit | max. value) Information
0 Incr. 327680 Lenze: 0 (From SM301 V1.3)
þ Read access } Write access o Controller inhibit o PLC-STOP o No transfer
C15312 SOS: Maximum change in position UNSIGNED_32 9263 d = 242F h
Amount of the maximum change in position while SOS was active
Display area (min. value | unit | max. value) Information
0 Incr. 2147483647 (From SM301 V1.3)
þ Read access o Write access o Controller inhibit o PLC-STOP o No transfer
C15315 SS1, SS2: ramp monitoring UNSIGNED_8 9260
d
= 242C
h
Selection whether the brake ramp is to be monitored when SS1 and SS2 are executed.
Selection list (Lenze setting bold) Information
0 No ramp monitoring (From SM301 V1.4)
1 Ramp monitoring is activated
þ Read access } Write access o Controller inhibit o PLC-STOP o No transfer
C15316 SS1, SS2: S−ramp time UNSIGNED_8 9259
d
= 242B
h
S−ramp time of deceleration ramp for SS1 and SS2 if a linear ramp is not used.
Setting range (min. value | unit | max. value) Information
0 % 100 0 (From SM301 V1.4)
þ Read access } Write access o Controller inhibit o PLC-STOP o No transfer
C15317 SS1, SS2: Start offset ramp UNSIGNED_8 9258 d = 242A h
Speed offset at the start of the ramp monitoring.
Display area (min. value | unit | max. value) Information
0 % 30 0 (From SM301 V1.4)
þ Read access } Write access o Controller inhibit o PLC-STOP o No transfer
C15320 SMS: Max. speed Nmax INTEGER_16 9255 d = 2427 h
Selection of the maximum speed and activation of the SMS function
Setting range (min. value | unit | max. value) Information
0 rpm 16000 Lenze: 1, deactivate: 0
þ Read access } Write access o Controller inhibit o PLC-STOP o No transfer