Dell PowerEdge VRTX - Manual (Page 279)

RADIUS Commands 279
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Radius.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
no radius-server host source-interface
Parameters
• interface-id —Specifies the source interface.
Default Configuration
The source IPv4 address is the IPv4 address defined on the outgoing interface
and belonging to next hop IPv4 subnet.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface, the interface IP address
belonging to next hop IPv4 subnet is applied.
If the source interface is not the outgoing interface, the minimal IPv4 address
defined on the source interface is applied.
If there is no available IPv4 source address, a SYSLOG message is issued when
attempting to communicate with an IPv4 RADIUS server.
Example
The following example configures the VLAN 10 as the source interface.
console(config)# radius-server host source-interface vlan 100
radius-server host source-interface-ipv6
Use the radius-server host source-interface-ipv6 Global Configuration mode
command to specify the source interface whose IPv6 address will be used as
the source IPv6 address for communication with IPv6 RADIUS servers. Use
the no form of this command to restore the default configuration.
Syntax
radius-server host source-interface-ipv6 interface-id
no radius-server host source-interface-ipv6