Dell PowerEdge VRTX - Manual (Page 443)

Address Table Commands 443
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Address_Table.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
show bridge multicast address-table [vlan vlan-id] [address mac-multicast-
address] [format {ip | mac}]
show bridge multicast address-table [vlan vlan-id] [address ipv4-multicast-
address] [source ipv4-source-address]
show bridge multicast address-table [vlan vlan-id] [address ipv6-multicast-
address] [source ipv6-source-address]
Parameters
• vlan-id vlan-id —Display entries for specified VLAN ID.
• address—Display entries for specified Multicast address. The possible
values are:
–
mac-multicast-address—Specifies the MAC Multicast address.
– ipv4-multicast-address—Specifies the IPv4 Multicast address.
– ipv6-multicast-address—Specifies the IPv6 Multicast address.
• format—Applies if mac-multicast-address was selected. In this case either
MAC or IP format can be displayed. Display entries for specified Multicast
address format. The possible values are:
–
ip—Specifies that the Multicast address is an IP address.
– mac—Specifies that the Multicast address is a MAC address.
• source —Specifies the source address. The possible values are:
–
ipv4-address—Specifies the source IPv4 address.
– ipv6-address—Specifies the source IPv6 address.
Default Configuration
If the format is not specified, it defaults to mac (only if mac-multicast-
address was entered).
If VLAN ID is not entered, entries for all VLANs are displayed.
If MAC or IP address is not supplied, entries for all addresses are displayed.
Command Mode
Privileged EXEC mode