Comtech EF Data CDM-700 - Manual (Page 118)

CDM-700 High Speed Satellite Modem Revision 5
Front Panel Operation MN/CDM700.IOM
6–64
This ‘read-only’ status window indicates if the modem is Resolved, Duplex, Speed, or Not
Resolved.
Status Description
Resolved -or-
Not Resolved Displays whether Duplex and Speed has been Resolved or Not
Resolved.
Note: If GBEI Tx or Rx is Off, this is always blank.
Duplex This is only valid if Resolved.
Speed This is only valid if Resolved.
10Mbps
100Mbps
1000 Mbps
6.3.5 (SELECT:) Save/Load
Save/Load Configuration:
Save Load ( E)
Note: When the unit is in Remote mode, any attempt to use this menu (i.e., by using the ◄ ►
arrow keys), displays the following message:
THIS UNIT IS CURRENTLY
IN REMOTE MODE!!
When in Local mode: Select Save or Load using the ST arrow keys. Press
ENTER
. The Save
and Load submenus permit storing or loading of up to 10 different modem configurations in the
non-volatile memory of the modem.
Save/Load Configuration:
ÆSave
Save Config to Loc: 9
Empty
( ST E)
Using Loc 9: as the example, if Save is selected and no configuration has been saved, the second
line reads ‘Empty’, as shown in the preceding example.
However, if the selected Loc: 9 already contains data, what displays is similar to the next example:
Save Config to Loc: 9
01:02:43 05/08/05 (
ST E)
The time and date stamp of the previously stored configuration is displayed for identification
purposes.
Select the location to where the current configuration is to be stored, using the ST arrow keys,
then press
ENTER
. Locations 1 through 10 are available.