Comtech EF Data CDM-700 - Manual (Page 85)

CDM-700 High Speed Satellite Modem Revision 5
Front Panel Operation MN/CDM700.IOM
6–31
6.3.1.5 (CONFIG:) Intfc1 (CDI-50 OC-3 Interface)
The menus depicted in this section pertain to the CDI-50 OC-3 Optical and STM-1 Copper Interface.
Intfc1 OC-3:
Tx Rx Mode ( E)
Select Tx, Rx or Mode using the ◄ ► arrow keys. Press
ENTER
.
Intfc1 OC-3:
Æ Tx
Intfc1 OC-3 Tx:
Data Ena/Dis ( E)
Select Data or Ena/Dis using the ◄ ► arrow keys. Press
ENTER
.
If Intfc1 OC-3 Tx: Æ Data is selected:
Intfc1 Tx Data Rate:
155.520000 Mbps (E)
Intfc1 Tx Data Rate:
Disabled (E)
This is a ‘read only’ status window to display the data rate of the interface. When the Tx side of
this interface is enabled or disabled via Intfc1 OC-3 Tx: Æ Ena/Dis (see next section), that
status is reflected in this display:
• When Tx is enabled, the data rate of the interface is displayed, as shown in the top
example.
• When Tx is disabled, that status is reflected in this display, as shown in the bottom
example.
Press
ENTER
or
CLEAR
to return to the previous menu.
If Intfc1 OC-3 Tx: Æ Ena/Dis is selected:
Intfc1 Tx Status:
Enable Disable (E)
This selection activates or deactivates the transmit (Tx) side of this interface. Disabling the Tx
side deactivates it and changes the data rate to 0.
Select Enable or Disable using the
◄ ► arrow keys. Press
ENTER
.
Note: Disabling the Tx side will also turn off the output power.