Comtech EF Data CDM-700 - Manual (Page 157)

CDM-700 High Speed Satellite Modem Revision 5
Remote Control MN/CDM700.IOM
11–7
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Interface
Type N/A 3 bytes Query only.
Interface Type, where:
s=Defines which interface slot (1 or 2)
xx=Defines the interface type, where:
00=E3/T3/STS1
01=Reserved
02=Reserved
03=OC3
04=Gigabit Ethernet
05=HSSI
06 - 14=Reserved
15=Not Present
Example: ITF=100 (indicates that interface slot 1 is an
E3/T3/STS1 card.) N/A ITF?s ITF=sxx
(see description of
arguments)
Interface Tx
Data Rate ITR= 12 bytes Command or Query.
Interface Tx Data rate, in Mbps:
s=Defines which interface slot (1 or 2)
c=Defines which channel (1 to 2)
xxx.xxxxxx=Defines the transmit data rate in Mbps.
Resolution=1 bps.
Example: ITR=11002.047999 (which is 2.047999 Mbps) on slot
1 channel 1.
*Note: Interface types G.703 and GbEI cannot vary in
datarate. ITR=
ITR?
ITR*
ITR# ITR?sc ITR=scxxx.xxxxxx
(see description of
arguments)
Priority System = ITF (Highest priority) , TFT, TMD, and TCR (Lowest Priority), indicated by shading. Any change to a higher priority
parameter can override any of the parameters of lower priority.