Comtech EF Data CDM-700 - Manual (Page 93)

CDM-700 High Speed Satellite Modem Revision 5
Front Panel Operation MN/CDM700.IOM
6–39
Intfc1 Gigabit Ethernet:
Æ Tx
Intfc1 Tx:
Data Enable Alarm (E)
Select Data, Enable, or Alarm using the ◄ ► arrow keys. Press
ENTER
.
If Intfc1 Tx: Æ Data is selected:
Intfc1 Data Rate:
Tx:075.000000 Mbps (E)
Intfc1 Data Rate:
Tx: Disabled (E)
Edit the Tx Data Rate by selecting the digit to be edited, using the ◄ ► arrow keys. The value
of the digit is then changed using the ▲ ▼ arrow keys. The range of values is from 1.0 to 155.0
Mbps.
Note that the modem Symbol Rate limits of 1.0 to 64.0 Msps makes some choices of Modulation
Type, FEC Coding and Data Rate selection invalid. Once the Tx Data Rate is edited, Press
ENTER
.
If Tx: Disabled is displayed, the port is turned Off (0 Mbps).
If Intfc1 Tx: Æ Enable is selected:
Intfc1 Tx Enable:
Enable Disable (E)
This selection activates or deactivates the transmit (Tx) side of this interface. Disabling the Tx
side deactivates it and changes the data rate to 0.
Select Enable or Disable using the ◄ ► arrow keys. Press
ENTER
.
If Intfc1 Tx: Æ Alarm is selected:
GBEI Tx Cable Alarm:
Alarm Fault Mask (E)
This selection will affect the event reporting status upon detection of loss of GBEI Cable.
Select Alarm, Fault, or Mask using the ◄ ► arrow keys. Press
ENTER
.