Comtech EF Data CDM-700 - Manual (Page 62)

CDM-700 High Speed Satellite Modem Revision 5
Front Panel Operation MN/CDM700.IOM
6–8
6.3.1.1 (CONFIG:) Remote
Remote Control:
Local Serial Ethernet
Select Local, Serial or Ethernet by using the ◄ ► arrow keys, then press
ENTER
.
Selection Action
Local Remote control is disabled. Remote monitoring is still possible.
Serial RS232, RS485-2W, and RS485-4W menus are accessed.
Ethernet Additional submenus will be displayed.
Remote Control: Æ Local
IMPORTANT
When Local is selected, remote control is disabled and local control enabled
once ENTER is pressed; the CONFIG: menu returns. When Remote is selected,
menu operations associated with local control are disabled, and the following
message appears when menu or command access associated with Local
control is attempted:
THIS UNIT IS CURRENTLY
IN REMOTE MODE!!
Remote Control:
Æ Serial
Serial Config: Interface Baudrate
(E)
Select Interface or Baudrate using the ◄ ► arrow keys, then press
ENTER
.
If Serial Config: Æ Interface is selected:
M&C Bus Interface: RS232
RS485-2W RS485-4W (E)
Select RS232 or RS485-2W (2-wire) or RS485-4W (4-wire) using the ◄ ► arrow keys, then
press
ENTER
.
Note: At this point, a prompt requests entry of the bus address.