HEIDENHAIN iTNC 530 (340 49x-01) ISO programming - Manual (Page 453)

HEIDENHAIN iTNC 530 453
1
0
.9 Pr
eassigned Q P
a
ra
met
e
rs
Coordinates after probing during program run
The parameters Q115 to Q119 contain the coordinates of the spindle
position at the moment of contact during programmed measurement
with the 3-D touch probe. The coordinates are referenced to the
datum that is currently active in the Manual operating mode.
The length and radius of the probe tip are not compensated in these
coordinates.
Deviation between actual value and nominal
value during automatic tool measurement with
the TT 130
Tilting the working plane with mathematical
angles: Rotary axis coordinates calculated by the
TNC
Coordinate axis Parameter value
X axis Q115
Y axis Q116
Z axis Q117
IVth axis
dependent on MP100 Q118
Vth axis
dependent on MP100 Q119
Actual-nominal deviation Parameter value
Tool length Q115
Tool radius Q116
coordinates Parameter value
A axis Q120
B axis Q121
C axis Q122