HEIDENHAIN iTNC 530 (340 49x-01) ISO programming - Manual (Page 68)

68 2 Manual Operation and Setup
2.4 D
a
tu
m Set
ting (Without a 3-D T
o
uc
h Pr
obe)
Activating the datum from the preset table in the Manual
operating mode
Select the Manual Operation mode
Call the function for setting the datum
Call preset table
Release the preset table for editing: Set the EDIT
OFF/ON soft key to ON.
With the arrow keys, select the datum number that
you want to activate, or
With the GOTO key, select the datum number that
you want to activate. Confirm with the ENT key.
When activating a datum from the preset table, the TNC
resets all coordinate transformations that were activated
with the following cycles:
„ Cycle G53, Datum shift in datum table
„ Cycle G54, Datum shift in program
„ Cycle G28, Mirroring
„ Cycle G73, Rotation
„ Cycle G72, Scaling
However, the coordinate transformation from Cycle G80,
Tilted Working Plane, remains active.
DATUM SET X=