HEIDENHAIN iTNC 530 (340 49x-01) ISO programming - Manual (Page 6)

6
In addition, the iTNC 530 also has two software option packets that
can be enabled by you or your machine tool builder. Each packet is to
be enabled separately and contains the following respective functions:
Please contact your machine tool builder to become familiar with the
features of your machine.
Many machine manufacturers, as well as HEIDENHAIN, offer
programming courses for the TNCs. We recommend these courses as
an effective way of improving your programming skill and sharing
information and ideas with other TNC users.
Software option 1
Cylinder surface interpolation (Cycles G127, G128, G129 and G139)
Feed rate in mm/min on rotary axes: M116
Tilting the machining plane (Cycle G80, PLANE function (only
conversational format and 3D-ROT soft key in the manual operating
mode)
Circle in 3 axes (with tilted working plane)
Software option 2
Block processing time 0.5 ms instead of 3.6 ms
5 axis interpolation
Spline interpolation
3-D machining:
„ M114: Automatic compensation of machine geometry when
working with tilted axes
„ M128: Maintaining the position of the tool tip when positioning
with tilted axes (TCPM)
„ FUNCTION TCPM (only conversational format): Maintaining
the position of the tool tip when positioning with tilted axes
(TCPM) in selectable modes.
„ M144: Compensating the machine’s kinematic configuration for
ACTUAL/NOMINAL positions at end of block
„ Additional parameters finishing/roughing and tolerance for
rotary axes
in Cycle G62
„ LN blocks (3-D compensation)
Touch Probe Cycles User’s Manual:
All of the touch probe functions are described in a separate
manual. Please contact HEIDENHAIN if you require a copy
of this User’s Manual. ID number: 375 319-xx.