HEIDENHAIN TNC 640 (34059x-05) ISO programming - Manual (Page 615)

Machine-specific user parameters 19.1
19
TNC 640 | User's ManualDIN/ISO Programming | 1/2015
615
Parameter settings
NC stop during tool measurement
True: When breakage tolerance is exceeded the NC program is stopped
False: The NC program is not stopped
Modification of tool table during tool check and measurement
AdaptOnMeasure: Table modified after tool measurement
AdaptOnBoth: Table modified after tool check and measurement
AdaptNever: Table not modified after tool check and measurement
Configuring a round stylus
TT140_1
Coordinates of stylus center
[0]: X coordinates of stylus center referenced to machine datum
[1]: Y coordinates of stylus center referenced to machine datum
[2]: Z coordinates of stylus center referenced to machine datum
Safety clearance above stylus for pre-position
0.001 to 99 999.9999 [mm]: Safety clearance in tool axis direction
Safety zone around stylus for pre-position
0.001 to 99 999.9999 [mm]: Safety clearance in the plane vertically to the tool axis