Lyntec RPC - Manual (Page 18)

139-0498-0118
Chapter Four--Wiring
18
Switch Wiring Instructions The I/O ports on your RPC controller allow for a variety of
switch options.
LynTec SS-2 Switch Set Using a standard LynTec SS-2 Switch Set with illuminated ON
switch. See Figure 4-6
1. Wire the ON switch to Digital I/O port 2 on the left edge of
the Controller board as follows:
i. Connect the 24VDC Common (center terminal of the I/O
port) to the C pin of the ON switch. Jumper the C pin of
the ON switch to the + pin.
ii. Connect the Input terminal (arrow pointing towards
header) to the NO pin of the ON switch.
iii. Connect the Output terminal (arrow pointing away from
header) to the – pin of the ON switch.
2. Wire the OFF switch to Digital I/O port 3 on the left edge of
the Controller board as follows:
i. Connect the 24VDC Common terminal to the C pin of
the OFF switch.
ii. Connect the Input terminal to the NO pin of the OFF
switch
Figure 4-6
Lyntec SS-2 Wiring Diagram
Left Bus
IN
24V
OUT
Digital I/O
NO
C
NC
+ –
NO
C
NC
ON
OFF
1
2
3
4
5
6
OFF