Lyntec RPC - Manual (Page 35)

139-0498-01.35 35
Chapter Five--Control Setup
Contact Closure Setup
Confi gure the digital I/O port and link it to a zone as follows:
Note: If the Emergency Shutoff feature is selected, the fi rst
position in the Onboard fi eld (on the Controller) is automatically
assigned to that.
1. Rename each contact closure as desired
2. Select contact closure action type
3. Use CC Module 1 and CC Module 2 only if I/O Expander
boards are installed.
4. Save Changes
Figure 5-18
Assigning Contact Closures to Zones To assign a contact closure to a zone in the “Panel” screen:
1. Select the desired zone from the drop down box.
2. Save changes.
Figure 5-19