Inter-Tel Axxess - Manual (Page 102)

Page 86
System Hardware
AXXESS ® ADMINISTRATOR’S GUIDE – January 2004
Inter-Tel Phones
Normally, the secondary extension button will not show intercom calls. However, if the pri-
mary station does not have an IC button, intercom calls will appear under a Call button and,
therefore, will appear on the secondary extension button. If the primary station is a single-line
set, all calls will appear on the secondary extension button.
After answering a call on the secondary extension button, the station user can transfer it back
to the primary station using one of the following methods:
•
Transfer to hold: To transfer the call to hold at the primary station, press the secondary
extension button, announce the call, if desired, and then hang up.
•
Transfer to ring: To transfer a call to the primary station, press the button
and then the secondary extension button. You can announce the call, if desired, before
hanging up to complete the transfer.
Because the calls that appear on the secondary extension button are active only at the primary
station, they will not follow call forwarding or system forwarding paths at the station with the
secondary extension button.
Light-Emitting Diode (LED) Indications
The Inter-Tel phone Call buttons, trunk buttons, speed-dial buttons, hunt group buttons, and
some of the feature buttons contain light-emitting diodes (LEDs). The LED flash rates indicate
the status of the stations, trunks, and features.
FIGURE 8. Executone Phone LED Rates
TRANSFER
CALL/DEVICE STATUS LAMP RATE
Call Active
Device in DND
500ms on, 500 ms off (slow flash)
Call Holding
Data Call In Progress
Secondary Extension Holding
500ms flutter, 500 ms on, 500 ms flutter, 500
ms off (fluttering flash)
Call Ringing
Queue Callback
Help/Record-A-Call In Progress
Secondary Call Ringing
Device Ringing (DSS or Speed-Dial button)
Call Transferring
250ms on, 250 ms off (fast flash)
Call Recalling
Message Waiting
250ms on, 50 ms off (urgent flash)
Call On System Hold
Device Idle (DSS or Speed-Dial button)
50 ms on, 50 ms off (flutter)
Device Busy Solidly lit