Inter-Tel Axxess - Manual (Page 108)

Page 92
System Hardware
AXXESS ® ADMINISTRATOR’S GUIDE – January 2004
Digital Phone LED Rates
When a data device places an intercom call, the call is placed in the non-handsfree mode. (This
can be changed in database programming, if desired, by disabling the Ring Intercom Always
flag.) The incoming intercom call to the destination station from the data device appears as a
normal intercom call with the usual displays and tones.
If an extension number is dialed and that station is in Do-Not-Disturb, the user will hear Do-
Not-Disturb tone through the data device’s speaker (if it has one). Whenever continuous busy,
reorder, or Do-Not-Disturb tone is sent by the system, the Inactivity Alarm timer is registered.
The
button is lit while the tones are present. If the timer expires before the data device
hangs up, off-hook alarm tone is sent, and the button flutters rapidly until the device
hangs up. Note that once the button begins fluttering, the voice path on the phone
attached to the data port module is released and can be used for other call processing applica-
tions. (Note that the absence of a lamp or
button will not interfere with these timing
parameters, but the user will not have a visual indication of them.)
If the data port places an outside call, the system performs toll restriction using the data port’s
class-of-service. If an illegal extension number or access code is dialed, the user will hear reor-
der tone through the data device’s speaker. (Call cost information for a data call is displayed on
an associated phone only when the data call is connected to a phone’s primary voice path.)
If an attempt is made to initiate a data call from the data device when the required voice path is
not available (the secondary voice path of the attached phone is busy), the data device will not
receive dial tone. The activity on the phone’s secondary voice path continues uninterrupted.
T O PLACE A DATA CALL USING THE DATA DEVICE :
1. Following the procedures of your data device’s communications software, instruct the
device to come off hook and dial the extension number, or a trunk access code and the
telephone number, of the data device to be called. The call will be processed and will be
automatically connected when answered. The
button is lit until dialing is com-
pleted, then it flutters.
2. Operate the data device according to the manufacturer’s instructions.
The data device can be called directly (intercom or outside calls) and receive transferred calls
via its extension number.
When a call is placed directly or transferred to the device’s intercom number, the data device
will receive ring signal. If the data device does not have auto-answer capability, the user must
manually answer the call using the data device. (Transferring a call to the data device using the
button places the call without providing ring voltage to the data device. The user must
manually cause the data device to answer the call.)
While ring signal is being sent to the data device, the button flashes. As soon as the
data device answers, the button flutters. The button continues to flutter for the duration
of the call, indicating that the data path is in use but may be picked up by associated phones.
T O ANSWER A DATA CALL USING THE DATA DEVICE :
1. When the data device receives a call, the button flashes on the associated
phone(s). If the data device does not have an auto-answer modem, follow the procedures
for the data device’s communications software and instruct the device to answer the
incoming call. The
button flutters while the call is in progress.
2. Operate the data device according to the manufacturer’s instructions.
DATA
DATA
DATA
DATA
DATA
DATA
DATA
DATA
DATA
DATA