2 starting mobilenavigator 6, 1 initialising the gps receiver, Starting mobilenavigator 6 – Navigon Fujitsu Siemens Pocket LOOX N100 User Manual
Page 25: Initialising the gps receiver
User Manual MobileNavigator 6
Navigation
- 23 -
4.2
Starting MobileNavigator 6
1. Switch on your navigation device.
2. Tap on the navigation software icon.
Each time you start the navigation software, the following
window appears:
"Please note that the road traffic regulations are prior to the
instructions of the navigation system. Please do not operate
the device while driving."
3. When you have read the text completely, press the OK
button.
If you do not wish to accept this information , then tap on the
Cancel button in order to end the navigation software.
The M
AIN
W
INDOW
opens.
4.2.1
Initialising the GPS receiver
Note: It can take up to 20 minutes to initialise the GPS receiver
for the first time.
Each time you switch on the receiver after this, the GPS reception
will start within one minute..
If the navigation device has been switched off for over a week,
the next installation can take up to 10 minutes.
The GPS receiver starts initialisation as soon as the navigation
device is switched on.
In the top right corner of the display you will see the GPS icon. It
can show three different states:
Icon Meaning
Explanation
No GPS
The GPS receiver is switched off.
- OR –
an external GPS receiver has not been
connected properly.
No Signal
The data is being received from less than
three satellites. The position cannot be
calculated.
GPS ready
The data is being received from at least
three satellites. The position can be
calculated.