8 starting navigation, Defining destinations on the map – Navigon Fujitsu Siemens Pocket LOOX N100 User Manual
Page 39
User Manual MobileNavigator 6
Navigation
- 37 -
4.8
Starting navigation
You have specified a new destination (refer to chapter "Entering a
new destination" on page 25) and tapped on the Start navigation
button,
- OR –
You have specified a destination (refer to chapter "Selecting a
saved destination" on page 32) and tapped on the Start
navigation button,
- OR –
In the M
AIN
W
INDOW
you have tapped on the Take me home
button (refer to chapter "Navigating home", page 35),
- OR –
You have defined a destination on the map (refer to chapter
"Defining destinations on the map" on page 36) and tapped on
the Take me there button.
The map opens in Preview mode.
The navigation destination is shown by a small flag. The route
and the probable duration of journey are displayed.
The calculation of the route takes so-called route options as a
basis.
1. If you now wish to view or change these route options, tap on
the Route profile button.
Note: If you change the route options, these changes remain
valid for the following navigations.
Refer to chapter "Route profile" on page 87 for information on
changing the route profile.
2. Tap on the Start navigation button or simply get going.
No GPS reception
If an insufficient GPS signal is being received, the following
message appears:
"No GPS signal available at present. Would you like to use the
last known position?"
You have the following options:
Ù Tap on the OK button. The route will be calculated using the
last known position as a starting point. As soon as the GPS
reception is sufficient for positioning, the route will be
recalculated and you can commence navigation.
Ù Tap on the Cancel button. The M
AIN WINDOW
opens. Your
destination is saved in the L
AST DESTINATIONS
list.