B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 142)

142 Airborne Enterprise CLI Reference Manual
eth-mode
Command eth-mode
Arguments auto | 10half |10full | 100half | 100full
Security
Level
3 (config)
Device Type Ethernet
Default auto
Description Configures the connection rate for the wired Ethernet interface.
auto Auto negotiate
10half 10Mbps, half duplex
10full 10Mbps, full duplex
100half 100Mbps, half duplex
100full 100Mbps, full duplex
eth-role
Command eth-role
Arguments [client | router | bridge]
Security
Level
3 (config)
Device Type Ethernet
Default client – Serial, router - Ethernet
Description Configures the Ethernet interface role and determines the packet handling by the interface.
client Disables packet forwarding between the wired and wireless interfaces.
router
Enables packet forwarding between the wired and wireless
interfaces. Configuring the module as a NAT3 router.
bridge
Bridges the wired and wireless interfaces. All packets will be
passed between the interfaces. Packet routing is disabled.
The router mode is required when the device is configured as an Ethernet Adapter and packet routing
is used between the wired and wireless interfaces (WLNN-ER-DP5XX, ABDN-ER-DP5XX, and ABDN-ER-
IN5XXX).
The bridge mode is required when the device is configured as an Ethernet Adapter and data bridging is
used between the wired and wireless interfaces (WLNN-ER-DP5XX, ABDN-ER-DP5XX, and ABDN-ER-
IN5XXX can be easily converted to bridge mode using the Template option in AMC).
The client mode is preferred when the module is being used as a serial device server (WLNN-AN-
DP5XX, WLNN-SE-DP5XX, and ABDN-SE-IN5XXX).