B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 83)

Airborne Enterprise CLI Reference Manual 83
Step/Command Description
restart
The Airborne device should be restarted after the update process. This can
be achieved by issuing the restart command or power cycling the unit.
 Only firmware authorized by B&B Electronics may be used. Any attempt to use an alternative
image will void the modules warranty and potentially cause the module to stop functioning.

CRITICAL: When updating any firmware, power must be maintained during the entire update
process. Removal or interruption of the power supply, during the update, may produce a
corruption of the firmware update and cause the module to stop functioning. If this occurs
please contact B&B Electronics Technical Support.