B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 237)

Airborne Enterprise CLI Reference Manual 237
wl-ssh-port
Command wl-ssh-port
Arguments <integer>
Security
Level
3 (config)
Device Type All
Default 22
Description Configures the TCP port number used by the SSH (Secure Shell) server.
wl-tcp-ip / wl-tcp-ip-p1
Command wl-tcp-ip | wl-tcp-ip-p1
Arguments <IP Address: XXX.XXX.XXX.XXX>
Security
Level 3 (config)
Device Type Serial | UART | SPI
Default 0.0.0.0
Description Configures the primary network servers IP address for the Serial 1 (UART1) interface to use when the
CLI session on the Serial 1 (UART1) interface initiates a TCP connection. The address is used when the
pass
or serial-default pass commands are used.
If the IP address is empty or the connection is unsuccessful the CLI server will attempt a connection to
the server IP address defined by wl-tcp-ip2.
Use of the –p1 suffix is optional.
wl-tcp-ip2 / wl-tcp-ip2-p1
Command wl-tcp-ip2 | wl-tcp-ip2-p1
Arguments <IP Address: XXX.XXX.XXX.XXX>
Security
Level
3 (config)
Device Type Serial | UART | SPI
Default 0.0.0.0
Description Configures the secondary network servers IP address for the Serial 1 (UART1) interface to use when the
CLI session on the Serial 1 (UART1) interface initiates a TCP connection.
This address is used when the pass or serial-default pass commands are used and either the
primary IP address (wl-tcp-ip) is empty or the connection attempt to the primary IP address failed.
Use of the –p1 suffix is optional.