HEIDENHAIN TNC 306 Technical Manual - Manual (Page 103)

3/97
TNC 406/TNC 306 4-3
6.8 User-parameters 4-88
6.9 Code-numbers 4-89
6.10 Programming station 4-89
6.11 Decimal sign 4-89
6.12 Memory test 4-90
6.13 New program start/End of program run 4-90
6.14 Restore position 4-90
6.15 Overwrite Q-parameters 4-91
6.16 Color adjustment 4-91
7 M-functions 4-93
7.1 Generator ON/OFF (M36/M37) 4-96
7.2 Program-halt on M-functions 4-98
7.3 Program-halt on M06 4-99
7.4 M-function M89 4-99
8 Key simulation 4-101
8.1 TNC-keyboard 4-101
8.2 Machine control panel 4-110
9 Short circuit/probing 4-112
9.1 Interfacing the probing function 4-112
9.2 Successive probing 4-114
9.3 Manual probing 4-114
10 Handwheel 4-117
11 Analog inputs 4-120
12 Jog increment positioning 4-122
13 Datum correction 4-125
14 Electrode changer 4-127
14.1 Controlling an electrode changer 4-127
14.2 PLC program example 4-128
14.2.1 PLC module "TOOL CALL" 4-131
14.2.2 PLC module "REPLACE OLD TOOL" 4-132
14.2.3 PLC Module "PLC POS. NEUTRAL" 4-133
14.2.4 PLC module "SELECT NEW TOOL" 4-134
14.2.5 PLC module "POC. REG." 4-135
14.2.6 PLC Module "PLC POS. POC. 1/2/3/4/5" 4-136
14.2.7 PLC module "PLC POS. Z DOWN" 4-137
14.2.8 PLC module "PLC. POS. Z UP" 4-137