Luminex 100 IS User Manual, Version 2.3 - Manual (Page 110)

Luminex 100 IS User Manual Version 2.3
x
MAP Technology
5 - 68 PN 89-00002-00-071 Rev. C
define commands that apply to one or more wells, one or more
rows of wells, or one or more columns of wells. You can define
on-plate or off-plate commands.
Figure 5-37. Plate Layout Tab
9. Select wells. To select a single well, click the well. To select
multiple wells in a group, click and hold the mouse button with
the cursor over the first well, then drag the cursor around the
desired wells. To select a row or column click the letter or
number of the row or column.
10. Select plate commands. Right-click over the selected wells to
display the Command menu. See Figure 5-38. Select the desired
command. The associated command symbol appears in the
designated plate well. To make a correction, select the wells
(selected wells are outlined in blue), right-click over the selected
wells to display the Command menu, and then click Clear
Selection from the list. Table 5-10 (following) lists Plate Layout
selection shortcuts.
Note: Wells are always read in
rows (letters A to H) and col-
umns (numbers 1 to 12) start-
ing with A1. If partial
columns are selected they are
still read in the same order.