705 - save custom set, 706 - recall custom set, 707 - display character count – Visara 1330-X02 User Manual
Page 109: Display character count, Recall custom set, Save custom set, Display character count option (ascii), Recall custom set option (ascii), Save custom set option (ascii), Configuring the 1330 in ascii mode
701333-004
5-31
Configuring the 1330 in ASCII Mode
705 – Save Custom Set
Configuration Option 705 specifies which custom set you will immediately copy the
current set into.
n
o
i
t
p
O
e
c
i
o
h
C
g
n
i
n
a
e
M
5
0
7
4
–
1
4
h
g
u
o
r
h
t
1
t
e
s
m
o
t
s
u
C
To use this option, follow the configuration procedure that begins on Page 5-1.
706 – Recall Custom Set
Configuration Option 706 specifies which custom set you will immediately recall as the
current set. A soft POR will occur when you exit this option.
n
o
i
t
p
O
e
c
i
o
h
C
g
n
i
n
a
e
M
6
0
7
4
–
1
4
h
g
u
o
r
h
t
1
t
e
s
m
o
t
s
u
C
To use this option, follow the configuration procedure that begins on Page 5-1.
707 – Display Character Count
Configuration Option 707 displays the current character count on the status display. Use
this option to record the character count each time you change the print head, so that
Customer Service can better service the 1330.
The character count is displayed as n,nnn,nnn,nnn, with the appropriate n’s reading as
number values to reflect the current character count. For example, if the character count
is 1,220,000 characters, the display reads 0001220000. Record the character count on
the form provided in Appendix E each time you change the print head. The maximum
value for the character count is 9,999,999,999. Note these two points about the character
count:
• The character counter will count only characters, not graphics.
• Draft and near letter quality characters are counted equally, one per character. Print
head life, however, is based on draft characters only.
To view the character count, follow the configuration procedure that begins on Page 5-1.
When DISP CHR CNT appears on the second line of the display, press the Save key to
display the current character count. Record this figure on the form in Appendix E.
The displayed character count cannot be changed during this configuration option.