Preparing to operate the 1330 – Visara 1330-X02 User Manual
Page 33
701333-004
2-19
Preparing to Operate the 1330
Figure 2-17. Inserting Paper - Continuous Forms Module
7.
Raise the module flap and position the paper so the pinfeed holes along the edge of
the paper fit evenly over the tractor pins. Slide the tractor, if necessary, to adjust for
the paper width.
8.
When there is no slack in the paper, and it is aligned evenly, close the tractor doors.
9.
Flip the tractor lever down to lock it in place, referring to Figure 2-16.
10. Before you close the printer cover, set the platen gap lever as explained in the next
section.
11. Close the printer cover and lower the module flap.
Note:
Whenever you close the printer cover, be sure to take hold of any forms that
have exited through the top slot, to prevent the forms from jamming up inside
the printer.
12. Press the Start key to enable printing.