416 - paper skew sensor enable, 418 - dod load adjust, 419 - did load adjust – Visara 1330-X02 User Manual
Page 98: Did load adjust, Dod load adjust, Paper skew sensor enable, Paper skew sensor enable option (ascii), Configuring the 1330 in ascii mode
5-20
701333-004
Configuring the 1330 in ASCII Mode
416 – Paper Skew Sensor Enable
Use Configuration Option 416 to enable or disable the paper skew sensor. If you specify
NO (by entering 0), the paper skew sensor is disabled.
Note:
Paper skew is checked only when the Forms module is in DID mode.
n
o
i
t
p
O
e
c
i
o
h
C
g
n
i
n
a
e
M
6
1
4
)
o
N
(
0
d
e
l
b
a
s
i
d
s
i
r
o
s
n
e
s
w
e
k
s
r
e
p
a
p
e
h
T
)
s
e
Y
(
1
)
t
l
u
a
f
e
d
(
d
e
l
b
a
n
e
s
i
r
o
s
n
e
s
w
e
k
s
r
e
p
a
p
e
h
T
To specify your choice, follow the configuration procedure that begins on Page 5-1.
Enter your choice (0 or 1) and press Save.
418 – DOD Load Adjust
Use Configuration Option 418 to set the distance between the top of the form and the
bottom of the characters in the first print line. Values range from 20 to 255, in .007-inch
increments. For example, if you have a box you want to print in as the first print line,
measure the distance from the physical top of the form to the line you want to print on.
Convert the distance to .007 inches and enter the distance as the value for the Load
Adjust parameter.
Note that you will only be able to access the option that corresponds to the device you
have in the printer; that is, if you have a DOD device, the menu will only allow you to
access the DOD Load Adjust option. Loads can be initiated in Stop or Ready mode with
a DID device, but only in Ready mode with a DOD device.
419 – DID Load Adjust
Use Configuration Option 419 to set the distance between the top of the form and the
bottom of the characters in the first print line. Values range from 20 to 255, in .007-inch
increments. For example, if you have a box you want to print in as the first print line,
measure the distance from the physical top of the form to the line you want to print on.
Convert the distance to .007 inches and enter the distance as the value for the Load
Adjust parameter.
Note that you will only be able to access the option that corresponds to the device you
have in the printer; that is, if you have a DID device, the menu will only allow you to
access the DID Load Adjust option. Loads can be initiated in Stop or Ready mode with
a DID device, but only in Ready mode with a DOD device.