Visara 1330-X02 - Manual (Page 121)

701333-004 7-7
Maintaining the 1330
Checking Print Registration
1. Make sure that 14-inch wide (35.6-cm wide) paper is loaded in the printer.
2. Make sure that the 1330 is in Stop mode. If necessary, press the Stop key.
3. Select Option D02 under the Diagnostic menu.
4. Press the Save key to start the test. The display window will show the test number
and the message TEST IS RUNNING.
The 1330 will print columns of Hs, which will enable you to check the print
registration.
5. Press the Stop key to stop the test. The test number and name will be displayed.
6. Examine the printout. If the print registration looks good and you do not want to
adjust it, go to Step 11.
or
If you do want to adjust the print registration, go on to Step 7.
7. Press the Stop key.
8. Select Option 413, Horizontal Registration.
9. Compare the Hs on the printout with the (enlarged) characters in Figures 7-6 and
7-7. If the characters with the greater than (>) symbol are offset to the left of the
characters on the following line, you should increase the horizontal registration
value. For example, if the current value is 131 and the characters are offset to the
left, increase the value to 141.
> H H H H
H H H H
> H H H H
H H H H
> H H H H
H H H H
Figure 7-6. Increase Print Registration Value
If the characters with the greater than symbol are offset to the right of the characters
on the following line, you should decrease the horizontal registration value. For
example, if the current value is 131, decrease it to 121.