Visara 1330-X02 - Manual (Page 15)

701333-004 2-1
Chapter 2. Preparing to Operate
the 1330
The 1330 printer has been designed for customer setup and preliminary check. Please
read this chapter before you try to install or relocate your 1330.
Inspecting the Package
When the packaged 1330 printer arrives, inspect the carton for physical damage before
unpacking it. If the carton is damaged, do not open it. Notify the Traffic Department or
your sales representative, as appropriate.
Also call the delivery carrier to request examination of the damage. The carrier is required
to complete and sign a damage report form.
If you do not see any damage, unpack the printer according to the following instructions.
Unpacking the Printer
Refer to Figure 2-1 and follow these steps to unpack the 1330:
Caution
The 1330 weighs 66 pounds (29.9 kg). Two people may be required to move the printer
to its operating location.
1. Move the packaged printer to the work area and place the carton in an upright position.
2. Remove the packing list envelope from the outside of the box.
3. Open the flaps to the top of the box.
4. Remove the operator’s manual from the top of the printer.
5. Remove the continuous forms module feature (if ordered) located on top of the
printer.
6. Remove the printer from the box and remove the foam end caps and the bag from
the printer.
7. Remove the protective film from the top of the printer.
8. Lift the printer cover and remove the ribbon and power cord.