Vivotek MD9584-HF3 5MP Outdoor Network Mobile Dome Camera with Night Vision, Heater & 3.6mm Lens - Manual (Page 229)

VIVOTEK
User's Manual - 229
© 2022 VIVOTEK INC. All Right Reserved
98
Group: ircutcontrol_c<0~(n-1)> for n channel products (capability_daynight_c<0~(n-1)>_support >
0)
n denotes the value of "capability_nvideoin"
NAME VALUE SECURIT
Y
(get/set) DESCRIPTION
mode auto,
day,
night,
di,
schedule…etc
* Available values
are listed in
"capability_daynig
ht_c<0~(n-1)>_mo
de"
<product
dependent>
6/6 Set IR cut control mode
* We support this parameter when
the version number (httpversion) is
equal or greater than 0312a.
sir
<product dependent>
<boolean> 6/6 Enable/disable Smart IR
* Only available when
"capability_daynight_c<0~"capability_
nvideoin"-1>_smartir" is 1
* We support this parameter when
the version number (httpversion) is
equal or greater than 0312a.
daymodebegintime 00:00~23:59 6/6 Day mode begin time
* We support this parameter when
the version number (httpversion) is
equal or greater than 0312a.
daymodeendtime 00:00~23:59 6/6 Day mod end time
* We support this parameter when
the version number (httpversion) is
equal or greater than 0312a.
bwmode <boolean> 6/6 Switch to B/W in night mode if
enabled.
* Only available when
"capability_daynight_c<0~(n-1)>_
blackwhitemode" is 1.
© 2022 VIVOTEK INC. All Right Reserved
99
* We support this parameter when
the version number (httpversion) is
equal or greater than 0312a.
sensitivity low,normal,high,1
~100 6/6 Sensitivity of day/night control.
There are two value format:
"low,normal,high" : if
capability_daynight_c<0~(n-1)>_ircuts
ensitivity_type=options
"1~100" : if
capability_daynight_c<0~(n-1)>_ircuts
ensitivity_type=normalize
* Only available when
"capability_daynight_c<0~(n-1)>
_ircutsensitivity_type" is not "-".
* We support this parameter when
the version number (httpversion) is
equal or greater than 0312a.
7.10.2 IR cut control Illuminators
Group: ircutcontrol_illuminators (capability_daynight_c<0~(n-1)>_support > 0)
n denotes the value of "capability_nvideoin"
k is determined by the below criterion:
The following applies for capability_extension_do_num >= 0
* if extension_connected=1, k=capability_ndo
* if extension_connected=0, k=capability_ndo+ capability_extension_do_num
Otherwise,
* k=capability_ndo
NAME VALUE SECURIT
Y
(get/set) DESCRIPTION
builtin_irled_enabled <boolean> 6/6 Enable/disable built-in IR led
* Only available when
"capability_daynight_illuminators_buil