Vivotek MD9584-HF3 5MP Outdoor Network Mobile Dome Camera with Night Vision, Heater & 3.6mm Lens - Manual (Page 271)

VIVOTEK
User's Manual - 271
© 2022 VIVOTEK INC. All Right Reserved
140
NAME VALUE SECURITY
(get/set) DESCRIPTION
group for 1st channel, bit 16~31 are
the 2nd group for 2nd channel.
nvideoin = 3, bit 0~9 are the 1st group
for 1st channel, bit 10~19 are the 2nd
group for 2nd channel, bit 20~31 are
the 3rd group for 3rd channel.
Then, the 1st bit of the group
indicates 1st stream of a channel
support ePTZ or not. The 2nd bit of
the group indicates 2nd stream of a
channel support ePTZ or not, and so
on.
* For most products, the last stream
of a channel will not support ePTZ. It
is reserved for full view of the
channel. For some dual-stream
products, both streams support ePTZ.
nanystream 0, <positive integer> 0/7 number of any media stream per
channel
iva <boolean> 0/7 Indicate whether to support
Intelligent Video analysis
whitelight
<Not
recommended to
use this>
<boolean> 0/7 Indicate whether to support white
light led.
* We replace this parameter with
"capability_daynight_c<0~(n-1)>_built
inwled" when the version number
(httpversion) is equal or greater than
0309d.
iris <boolean> 0/7 Indicate whether to support iris
control.
supportsd <boolean> 0/7 Indicate whether to support local
storage.
fisheye <boolean> 0/7 The parameter is used to determine
whether the product is fisheye or not.
tampering <boolean> 0/7 Indicate whether to support
tampering detection.
© 2022 VIVOTEK INC. All Right Reserved
141
NAME VALUE SECURITY
(get/set) DESCRIPTION
tamperingmode tamper,toodark,toobri
ght,tooblurry 0/7 Available tampering mode list.
* Only available when
"capability_tampering" is 1.
adaptiverecording <boolean> 0/7 Indicate whether to support adaptive
recording.
adaptivestreaming <boolean> 0/7 Indicate whether to support adaptive
streaming.
supporttriggertype
s seq,boot,motion,netw
orkfail,recnotify,tamp
ering,vi,vadp,di,volala
rm,temperature,pir,
visignal,
backup,smartsd,
shockalarm,virestore,
presetreached,
casingopen
<product dependent>
0/7 list all the trigger types which are
supported in the camera:
"seq" = Periodic condition
"boot" = System boot
"motion" = Video motion detection
"networkfail" = network connection
failure
"recnotify" = Recording notification.
"tampering" = Tamper detection.
"vi" = Virtual input (Manual trigger)
"vadp" = VADP trigger.
"di"= Digital input.
"volalarm" = Audio detection.
"temperature" = Temperature
detection.
"pir" = PIR detection.
"visignal" = Video input signal loss.
"backup" = Backing up recorded files.
"smartsd" = Lifetime detection of SD
card.
"shockalarm" = Shock detection.
"virestore" = Video input signal
restore.
"presetreached" = When any preset is
reached
"casingopen" = Casing open detection.
* Only available when [httpversion] >=
0301a
media_num 0,<positive integer> 0/7 Number of media number.