Brocade TurboIron 24X Series Configuration Guide - Manual (Page 11)

Brocade TurboIron 24X Series Configuration Guide xi
53-1003053-01
sFlow . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 241
sFlow support for IPv6 packets. . . . . . . . . . . . . . . . . . . . . . . . .242
Configuration considerations . . . . . . . . . . . . . . . . . . . . . . . . . .243
Configuring and enabling sFlow . . . . . . . . . . . . . . . . . . . . . . . .244
Displaying sFlow information . . . . . . . . . . . . . . . . . . . . . . . . . .249
Configuring a utilization list for an uplink port . . . . . . . . . . . . . . . .251
Command syntax . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .252
Displaying utilization percentages for an uplink . . . . . . . . . . .252
Chapter 14 Configuring Basic Layer 2 Features
Enabling or disabling the Spanning Tree Protocol (STP). . . . . . . . .255
Modifying STP bridge and port parameters . . . . . . . . . . . . . . .256
Changing the MAC age time and disabling MAC address learning256
Disabling the automatic learning of MAC addresses . . . . . . .256
Displaying the MAC address table . . . . . . . . . . . . . . . . . . . . . .257
Configuring static MAC entries . . . . . . . . . . . . . . . . . . . . . . . . . . . . .257
Multi-port static MAC address. . . . . . . . . . . . . . . . . . . . . . . . . .258
Configuring VLAN-based static MAC entries . . . . . . . . . . . . . . . . . .259
Enabling port-based VLANs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .259
Assigning IEEE 802.1Q tagging to a port . . . . . . . . . . . . . . . . .260
Defining MAC address filters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .260
Configuration notes and limitations . . . . . . . . . . . . . . . . . . . . .261
Command syntax . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .261
Enabling logging of management traffic
permitted by MAC filters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .263
MAC address filter override for 802.1X-enabled ports . . . . . . . . . .264
MAC address filter override configuration notes . . . . . . . . . . .264
MAC address filter override configuration syntax . . . . . . . . . .264
Displaying and modifying system parameter default settings . . . .265
Configuration considerations . . . . . . . . . . . . . . . . . . . . . . . . . .265
Displaying system parameter default values . . . . . . . . . . . . . .265
Modifying system parameter default values . . . . . . . . . . . . . .267
Egress buffer thresholds for QoS priorities . . . . . . . . . . . . . . . . . . .267
Cut-Through Switching Support. . . . . . . . . . . . . . . . . . . . . . . . .269
Default settings for egress buffer thresholds . . . . . . . . . . . . .269
Disabling and re-enabling the default settings
for egress buffer thresholds . . . . . . . . . . . . . . . . . . . . . . . . . . .269
Setting the egress buffer threshold for all QoS
priorities on a port or group of ports . . . . . . . . . . . . . . . . . . . .270
Setting the egress buffer threshold for a specific
QoS priority on a port or group of ports . . . . . . . . . . . . . . . . . .270
Link Fault Signaling (LFS) for 10G . . . . . . . . . . . . . . . . . . . . . . . . . . 271
Jumbo frame support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .272