Brocade TurboIron 24X Series Configuration Guide - Manual (Page 68)

34 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Configuring basic port parameters
Use the show rate-limit unknown-unicast command to display the unknown unicast limit for each
port region to which it applies.
Syntax: show rate-limit unknown-unicast
Use the show rate-limit broadcast command to display the broadcast limit or broadcast and
multicast limit for each port to which it applies.
Syntax: show rate-limit broadcast
Configuring basic port parameters
The procedures in this section describe how to configure the port parameters shown in Table 14 .
All ports are pre-configured with default values that allow the device to be fully operational at initial
startup without any additional configuration. However, in some cases, changes to the port
parameters may be necessary to adjust to attached devices or other network requirements.
TurboIron#show rate-limit unknown-unicast
Unknown Unicast Limit Settings:
Port Region Combined Limit Packets/Bytes
1 - 12 524288 Packets
13 - 24 65536 Bytes
TurboIron#show rate-limit broadcast
Broadcast/Multicast Limit Settings:
Port Limit Packets/Bytes Packet Type(s)
4 1245184 Bytes Broadcast + Multicast
5 1245184 Bytes Broadcast + Multicast
14 65536 Packets Broadcast only
23 131072 Packets Broadcast + Multicast
TABLE 14 Basic port parameters
Port parameter See page
Name page 35
Speed page 35
Duplex mode page 36
Port status (enable or disable) page 36
Flow control page 37
Auto-negotiation and advertisement of flow control page 37
Configuring PHY FIFO Rx and TX Depth page 38
Interpacket Gap (IPG) page 38
Gbps fiber negotiate mode page 39
QoS priority page 39
Port flap dampening page 39