Entering the route map into the software – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 746
712
Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Filtering
•
Set the MED (metric).
•
Set the IP address of the next hop router.
•
Set the origin to IGP or INCOMPLETE.
•
Set the weight.
For example, when you configure parameters for redistributing routes into RIP, one of the optional
parameters is a route map. If you specify a route map as one of the redistribution parameters, the
router will match the route against the match statements in the route map. If a match is found and
if the route map contains set statements, the router will set attributes in the route according to the
set statements.
To create a route map, you define instances of the map. Each instance is identified by a sequence
number. A route map can contain up to 50 instances.
To define a route map, use the procedures in the following sections.
Entering the route map into the software
To add instance 1 of a route map named “GET_ONE” with a permit action, enter the following
command.
TurboIron(config)#route-map GET_ONE permit 1
TurboIron(config-routemap GET_ONE)#
Syntax: [no] route-map <map-name> permit | deny <num>
As shown in this example, the command prompt changes to the Route Map level. You can enter
the match and set statements at this level. Refer to
“Specifying the match conditions”
“Setting parameters in the routes”
The <map-name> is a string of characters that names the map. Map names can be up to 32
characters in length.
The permit | deny parameter specifies the action the router will take if a route matches a match
statement.
•
If you specify deny, the Layer 3 Switch does not advertise or learn the route.
•
If you specify permit, the Layer 3 Switch applies the match and set statements associated with
this route map instance.
The <num> parameter specifies the instance of the route map you are defining. Each route map
can have up to 50 instances.
To delete a route map, enter a command such as the following. When you delete a route map, all
the permit and deny entries in the route map are deleted.
TurboIron(config)#no route-map Map1
This command deletes a route map named “Map1”. All entries in the route map are deleted.
To delete a specific instance of a route map without deleting the rest of the route map, enter a
command such as the following.
TurboIron(config)#no route-map Map1 permit 10
This command deletes the specified instance from the route map but leaves the other instances of
the route map intact.