Brocade TurboIron 24X Series Configuration Guide - Manual (Page 974)

940 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Viewing traffic policies
Syntax: show traffic-policy [<TPD name>]
To display all traffic policies, enter the show traffic-policy command without entering a <TPD
name>.
TABLE 145 Traffic policy information
This line... Displays...
Traffic Policy The name of the traffic policy.
Metering Shows whether or not rate limiting was configured as part of the traffic policy:
•
Enabled – The traffic policy includes a rate limiting configuration.
•
Disabled – The traffic policy does not include a rate limiting configuration
Mode If rate limiting is enabled, this field shows the type of metering enabled on the port:
•
Fixed Rate-Limiting
•
Adaptive Rate-Limiting
cir The committed information rate, in kbps, for the adaptive rate-limiting policy.
cbs The committed burst size, in bytes per second, for the adaptive rate-limiting policy.
pir The peak information rate, in kbps, for the adaptive rate-limiting policy.
pbs The peak burst size, in bytes per second, for the adaptive rate-limiting policy.
Counting Shows whether or not ACL counting was configured as part of the traffic policy:
•
Enabled – Traffic policy includes an ACL counting configuration.
•
Disabled – Traffic policy does not include an ACL traffic counting configuration.
Number of
References/Bindings The number of port regions to which this traffic policy applies. For example, if the traffic
policy is applied to a trunk group that includes ports e 9, 10, 11, and 12, the value in this
field would be 2, because these four trunk ports are in two different port regions.
TurboIron#show traffic-policy t_voip
Traffic Policy - t_voip:
Metering Enabled, Parameters:
Mode: Adaptive Rate-Limiting
cir: 100 kbps, cbs: 2000 bytes, pir: 200 kbps, pbs: 4000
bytes
Counting Not Enabled
Number of References/Bindings:1