Brocade TurboIron 24X Series Configuration Guide - Manual (Page 817)

Brocade TurboIron 24X Series Configuration Guide 783
53-1003053-01
IGMP snooping show commands
To display the IGMP snooping information for a specific VLAN (release 04.1.00 or later), enter a
command such as the following.
Syntax: show ip multicast vlan [<vlan-id>]
If you do not specify a <vlan-id>, information for all VLANs is displayed.
This display shows the following information.
Displaying IGMP snooping errors
To display information about possible IGMP errors, enter the following command.
TurboIron#show ip multicast error
snoop SW processed pkt: 173, up-time 160 sec
Table 0.3:
This field... Displays...
Version The global IGMP version. In this example, the device is configured for IGMP version 2.
Query How often a querier sends a general query on the interface. In this example, the general
queries are sent every 125 seconds.
Group Age The number of seconds membership goups can be members of this group before aging out.
Max Resp The maximum number of seconds a client waits before replying to a query.
Other Qr How long it took a switch with a lower IP address to become a new querier. This value is 2 x
Query + Max Resp.
cfg The IGMP version for the specified VLAN. In this example, VL10: cfg V3 indicates that VLAN 10
is configured for IGMP V3.
(type of VLAN
config) One of the following may be displayed:
•
VLAN cfg: The IGMP configuration mode, which is either passive or active.
•
VLAN dft: The default configuration on this VLAN
•
glb cfg: Theconfiguration is picked up from the global configuration, which means this
VLAN does not have any specific config for pimsm.
pimsm Indicates that PIM SM is enabled on the VLAN.
rtr port The router ports, which are the ports receiving queries.
TurboIron#show ip multicast
Summary of all vlans. Please use "sh ip mu vlan vlan-id" for details
Version=2, Intervals: Query=125, Group Age=260, Max Resp=10, Other Qr=260
VL10: cfg V3, vlan cfg passive, , pimsm (vlan cfg), 1 grp, 0 (SG) cache, no rtr
port
TurboIron#show ip multicast vlan 10
Version=3, Intervals: Query=10, Group Age=260, Max Resp=10, Other Qr=30
VL10: cfg V3, vlan cfg passive, , pimsm (vlan cfg), 3 grp, 1 (SG) cache, no rtr
port,
e2 has 3 groups, non-QR (passive), default V3
**** Warning! has V2 client (life=240),
group: 239.0.0.3, life = 240
group: 224.1.1.2, life = 240
group: 224.1.1.1, life = 240
e4 has 0 groups, non-QR (passive), default V3